Transportation And Storage - Greencut Rlm610Xe Bedienungsanleitung

168
Poor cut, grass turns yellow after
mowing.
Grass clippings are discharged
uncleanly.
The mower won't start with the
electric starter.
Engine power decreases while
mowing.
Insufficient braking power.
NOTA: If you cannot resolve the problem, please contact the Official Technical Service.

TRANSPORTATION AND STORAGE

• Never store the machine with gasoline in the tank inside a building where fuel vapors could come into contact
with open flames or sparks.
• Drain the fuel tank completely and run it until it stops. This will remove all traces of gasoline and prevent future
carburetor problems. You can empty the gas tank with a gasoline suction pump.
• Keep the battery charged even when not in use; this will prevent the lithium cells from hardening, which will
shorten their lifespan.
• Let the equipment cool completely before transporting or storing it.
• To reduce the risk of fire, keep the engine, exhaust, battery box, and the area around the fuel tank free of grass,
straw, moss, leaves, or escaping grease.
• Never store the equipment in locations where there are flammable materials, combustible gases, or combustible
liquids, etc.
• Avoid placing the machine in a vehicle in direct sunlight. If the machine is left in a closed vehicle for many hours,
the high temperatures inside the vehicle can cause the fuel to evaporate and potentially cause an explosion.
• To prevent fuel loss during transport, the product should be secured in its normal operating position with the
fuel cap closed.
• Dull blade
• Cutting height too low
• Cutting height too low
• Worn blade
• Clogged basket
• Blocked chute
• Grass too wet
• Drive speed too high
• Dead battery
• Blown fuse
• The driving speed is too high in
relation to the cutting height.
• The brake is no longer adjusted
correctly.
• Sharpen the blade
• Adjust to the correct height
• Adjust the correct height
• Change the blade
• Empty the basket
• Clean the discharge chute
• Mow in dry weather
• Select a lower gear
• Charge the battery
• Replace the fuse
• Reduce the driving speed and
increase the cutting height.
• Contact customer service or a
specialist dealer.