Greencut RLM610XE Bedienungsanleitung Seite 147

MONTAJE
CAUTION: The mower is supplied without fuel or oil in the engine. Your new mower has been
tested at the production plant, which means the engine may contain a small amount of residual oil.
SEAT INSTALLATION
Remove the bolts and flange nuts from the seat
mounting brackets. Place the seat assembly onto the
mounting brackets, aligning the holes as shown. Replace
the bolts and flange nuts and tighten them securely.
Connect the seat safety cable to the socket.
TIE ROD INSTALLATION
Steering wheel sleeve
Place the axle on the lower tie rod to align the mounting
holes in the axle and the lower tie rod. After inserting
the bolts, tighten them with the flange nut. The
recommended tightening torque is 25±2 Nm. After
installing the axle, place the decorative tube on the
axle. Place the flange washer, bushing, flange washer,
and flywheel hub on the axle. Install the flywheel and
flat washer in the order and direction shown in the
figure. Align the mounting points of the flywheel and
the flywheel base and secure with the flange nut. The
recommended tightening torque is 24±2 Nm. Finally,
install the flywheel cover on the flywheel.
Nut
Flat washer
Steering wheel cap
Steering wheel
Adjusting washer
Decorative tube
Axle
Bolt
Nut
Tie rod
147
EN