Identificación Y Solución De Problemas; Possible Cause - Greencut Rlm610Xe Bedienungsanleitung

IDENTIFICACIÓN Y SOLUCIÓN DE PROBLEMAS
La tabla incluye algunos de los problemas más comunes, sus causas y remedios.
FAULT
Noisy during operation, the
machine vibrates strongly.
The engine won't start.
Engine overheats.
The machine won't work.
The engine runs unsteadily.

POSSIBLE CAUSE

• Loose bolts.
• Loose blade fasteners.
• Unbalanced blade.
• Damaged V-belt.
• Discharge chute blocked.
• Incorrect starting sequence
• Brake lever not engaged
• Gear lever not in "N" position
• Faulty spark plug
• Fuel tank empty
• Bowden cables too long
• Poor fuel, storage without
emptying the fuel tank,
incorrect gasoline type
• Fouled spark plug (carbon
residue on the electrodes), gap
too large
• Spark plug wet with gasoline
(flooded engine).
• Faulty engine
• Dirty cooling fins.
• Engine oil level too low.
• Worn V-belt.
• Gearbox disengaged.
• V-belt (gearbox) loose.
• V-belt (gearbox) worn or
defective.
• The key between the rear axle
and rear wheels is missing.
• The air filter is dirty
• The spark plug is dirty
SOLUTION
• Check bolts.
• Check blade fasteners.
• Replace the blade.
• Replace the V-belt.
• Clean the discharge chute.
• Checking the starting process
• Press the brake lever
• Check adjustment
• Replace the spark plug
• Refuel
• Adjust the Bowden cables with
the union nuts.
• Drain the fuel tank and carburetor.
Refill with fresh fuel.
• Clean the spark plug, check its
calorific value, and replace it as
necessary (adjustment between
0.6 and 0.8 mm).
• Dry the spark plug and reinsert it.
• Contact authorized customer
service.
• Clean the cooling fins.
• Check the engine oil level and top
up if necessary.
• Replace the V-belt.
• Engage the gearbox (freewheel
lever).
• Replace the V-belt (gearbox).
• Replace the V-belt (gearbox).
• Reinstall the key.
• Clean the air filter
• Clean the spark plug
167
EN