Herunterladen Inhalt Inhalt Diese Seite drucken

Storage; Storing The Device (22); Storing The Batteries And Charger - Al-Ko Solo R74.5 Li 36V Betriebsanleitung

Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 12

Storage

In both cases, it is essential to take the mandato-
ry precautions mentioned above to prevent any
leakage of the contents. In other cases, it is es-
sential to comply with the regulations of the haz-
ardous goods law. In the case of non-compli-
ance, severe penalties can be imposed on the
sender and possibly the transporter.
Additional notes on transport and shipment
Only transport or send the li-ion rechargeable
battery in an undamaged condition.
For transporting the rechargeable battery, on-
ly use the original cardboard box or a suitable
hazardous goods cardboard box (not re-
quired for rechargeable batteries with a nomi-
nal energy less than 100 Wh).
Tape off exposed rechargeable battery con-
tacts to avoid a short circuit.
Secure the rechargeable battery against
shifting in the packaging to avoid damage to
the rechargeable battery.
Ensure the correct marking and documenta-
tion of the shipment for transport or shipping
(e.g. by parcel service or freight forwarding).
Check in advance that transport with the se-
lected service provider is possible and indi-
cate the shipment.
We recommend involving a hazardous goods
specialist in preparation of the shipment. Also
heed any further national regulations.
11 STORAGE
Thoroughly clean the appliance after each
use and – if present – attach all covers.
Perform the required maintenance works.
Store the appliance in a dry, lockable place
out of the reach of children.

11.1 Storing the device (22)

CAUTION! Risk of injury during storage.
There is a risk of injury from sharp parts on the
stored device.
Store the device out of the reach of children
and unauthorised persons.
Always remove the safety key before stor-
age.
Remove all the batteries before storage.
Cover the cutting blades so that they cannot
be touched or rotated by hand.
1. Switch off the mower mechanism.
2. Set the cutting height to the highest level.
494504_a
3. Engage the parking brake (see chapter 3.7.5
"Parking brake (04)", page 48).
4. Switch off the ride-on mower.
5. Remove the safety key.
6. Wait until all rotating parts have come to a
standstill.
7. Pull out the batteries.
8. Allow the motors to cool down.
9. Remove the grass catcher.
10. Inspect the device for damage and have re-
paired, if necessary (see chapter 8.4 "Regu-
lar maintenance work (maintenance sched-
ule)", page 57).
11. Thoroughly clean the device and allow it to
dry.
12. Apply a thin coat of oil or silicon to all metal
parts for corrosion protection.
13. Storing the device:
Store in a dry, clean location protected
from frost. Storage temperature, see
Technical Data.
Keep out of the reach of children and un-
authorised persons.
Optional, if the grass catcher is removed:
Place the ride-on mower on its rear end
and secure it to prevent it from tipping
over.
Cover the cutting blades so that they
cannot be touched.
Cover with a breathable tarpaulin to pro-
tect against dust. Do not use plastic film
in order to avoid the accumulation of
moisture.
Remove tools used for the maintenance
work.
14. During storage, recharge the batteries once a
month to prevent deep-discharge.

11.2 Storing the batteries and charger

DANGER! Danger of explosion and fire!
Persons will be fatally or severely injured if the
rechargeable batteries explode because they
have been stored exposed to naked flames or
heat sources.
Store the rechargeable batteries in cool and
dry conditions, but not exposed to naked
flames or heat sources.
®
63
Inhaltsverzeichnis
loading

Inhaltsverzeichnis