Carrying Out A Self-Test; Transport; Storage; Disposal - AL-KO R85.1 Li Betriebsanleitung

GB
9.2

Carrying out a self-test

Activating a self-test
1. Sit on the operator's seat.
2. Set the driving mode switch (05/1) to N (Neu-
tral).
3. Turn the safety key (07/1) to green (ON posi-
tion).
4. Press the following buttons in the following
order within 2 minutes: CCS (04/1) >
RMO (04/2) > CCS (04/1) > RMO (04/2)
Carrying out a self-test
1. Press the brake pedal (09/1): Is working if a
beep is heard.
2. Press the drive pedal (10/1): Is working if a
beep is heard.
3. Press the locking lever (08/1) upwards to ac-
tivate the parking brake: Is working if a beep
is heard.
4. Press the RMO button (04/2). Is working if
the button is lit and a beep is heard.
5. Press the LED button (04/3). Is working if the
headlights are on.
6. Press the CCS button (04/4). Is working if the
button is lit and a beep is heard.
7. Set the driving mode switch (05/1) to F (For-
wards) and then press the drive pedal (10/1).
Is working if the ride-on mower moves for-
ward.
8. Set the driving mode switch (05/1) to R (Re-
verse) and then press the drive pedal (10/1).
Is working if the ride-on mower reverses.
9. Set the drive mode switch (05/1) to F (For-
wards) and then pull the push/pull
switch (03/1) upwards to switch on the mow-
er mechanism. Is working if the cutting
blades rotate.
If defective
1. Contact a service centre of the manufacturer.

10 TRANSPORT

When transporting the ride-on mower using
transport equipment (e.g. passenger car trailer),
the mower mechanism must be supported from
below to reduce the strain on the mower mecha-
nism mounting.
During transport, make sure that the means of
transport has a sufficient load capacity and that
the ride-on mower is suitably secured.
48

11 STORAGE

The ride-on mower should be parked where it is
protected against the effects of weather, espe-
cially moisture, rain and lengthy exposure to di-
rect sunlight. Particularly the UV radiation con-
tained in sunlight can cause plastic parts to fade,
and damage them, in the event of long-term ex-
posure.
1. Clean and allow to dry (see chapter 8.2
"Cleaning the ride-on mower", page 44).
2. Store the ride-on mower as follows:
■
in a dry, frost-free place
■
Storage temperature of 0 °C – 35 °C
■
Charge status of the rechargeable bat-
tery: 3–4 bars on the charge status dis-
play
3. Cover with a cloth to prevent soiling.
Note: Do not use plastic foil. Water and
moisture can accumulate under plastic foil.
After approx. 3 months' storage, recharge the re-
chargeable battery for approx. 1 hour. When
charging, the rechargeable battery is protected
from overcharging by automatic detection of the
charge status. This means it can remain connect-
ed to the charging unit for some time, but not per-
manently.

12 DISPOSAL

12.1 Removing the rechargeable battery

Before disposing of the ride-on mower, the re-
chargeable battery must be removed in accor-
dance with the safety regulations. Commission a
service center of the manufacturer or a specialist
dealer for this.

12.2 Legal notes

Information on the German Electrical and
Electronic Equipment Act (ElectroG)
■
Electrical and electronic appliances do
not belong in household waste, but
should be collected and disposed of
separately.
■
Used batteries or rechargeable batteries that
are not installed permanently in the old appli-
ance must be removed before disposal. Their
disposal is regulated by the battery law.
■
Owners or users of electrical and electronic
appliances are obliged by law to return them
after use.
Transport
R85.1 Li