Parkside PABS 20-LI I9 Bedienungsanleitung Und Originalbetriebsanleitung Seite 39

Large-diameter holes: Use a
Forstner bit.
Small screws can be screwed directly
into soft wood.
Belt clip
(Fig. C)
CAUTION! Risk of injury!
m
Before hanging the product in the
u
belt: Push the rotation direction
switch to the centre position
[ 6 ]
(lock). This prevents the product
from being switched on accidentally.
NOTE
The belt clip
u [ 9 ]
hooked on belt or pocket.
The belt clip
u 9 ] [
either side of a belt.
For the assembly of the belt clip
u
cross tip screwdriver is required.
1. Use a cross tip screwdriver to loosen
the screw of the belt clip
2. Insert the belt clip
the product.
3. Use a cross tip screwdriver to tighten
the screw.
˜ Cleaning and care
WARNING!
m
Always switch the product off
remove the battery pack
and let the product cool down
before performing inspection,
maintenance and cleaning work!
allows the tool to be
can be mounted on
9 ] [
.
9 ] [
on either side of
9 ] [
[ ]
˜ Cleaning
NOTE
Do not use chemical, alkaline,
u
abrasive or other aggressive
detergents or disinfectants to
clean this product as they might be
harmful to its surfaces.
Never allow uids to get into
o
the product.
The product must always be kept
o
clean, dry and free from oil or grease.
Remove debris from it after each use
and before storage.
Regular and proper cleaning will help
o
ensure safe use and prolong the life of
the product.
Clean the product with a dry cloth. Use
o
a soft brush for areas that are hard
to reach.
In particular clean the air vents after
o
a every use with a cloth and soft brush.
The vents must always be clear.
o
˜ Maintenance
Before and after each use, check
o
the product and accessories (e.g.
accessory tools) for wear and damage.
If required, exchange them for new
ones as described in this instruction
manual. Observe the technical
requirements (see "Technical data").
˜ Repair
This product does not contain any
o
parts that can be repaired by the user.
Contact an authorised service centre
or a similarly qualified person to have it
checked and repaired.
˜ Storage
Push the rotation direction switch
o
to the centre position to lock the on/off
switch .
[ 7 ]
Clean the product as described above.
o
[ 6 ]
GB/IE 37