Parkside PABS 20-LI I9 Bedienungsanleitung Und Originalbetriebsanleitung Seite 33

3) When battery pack is not in use,
keep it away from other metal
objects, like paper clips, coins,
keys, nails, screws or other small
metal objects, that can make a
connection from one terminal
to another Shorting the battery
terminals together may cause burns
or a fire.
4) Under abusive conditions,
li id ma be ejected rom the
battery; avoid contact. If contact
accidentall occ rs
water I li id contacts e es
additionally seek medical
help Liquid ejected from the battery
may cause irritation or burns.
5) Do not use a battery pack
or tool that is damaged or
modi ed Damaged or modified
batteries exhibit unpredictable
behaviour resulting in fire e plosion
or risk of injury.
6) Do not expose a battery pack or
tool to re or e cessi e tempera-
t re E posure to fire or temperature
above 130 °C may cause explosion.
7) Follow all charging instruction
and do not charge the battery
pack or tool outside the
temperat re range speci ed in the
instr ction Charging improperly or
at temperatures outside the specified
range may damage the battery and
increase the risk of the fire.
Service
1) Have your power tool serviced by
a ali ed repair person sing onl
identical replacement parts This
will ensure that the safety of the
power tool is maintained.
2) Never service damaged battery
pac s Service of battery packs
should only be performed by the
˜ Drill safety warnings
1)
sh with
2.
1)
2)
3)
˜ Vibration and noise reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-noise
operating modes as well as wear personal
protective equipment.
manufacturer or authorized service
providers.
Sa et instr ctions or
all operations
Hold the power tool by insulated
gripping surfaces, when performing
an operation where the accessory
tool or fasteners may contact
hidden wiring. Accessory tools or
fasteners contacting a "live" wire may
make exposed metal parts of the
power tool "live" and could give the
operator an electric shock.
Safety instructions when using long
drill bits
Never operate at higher speed
than the maximum speed rating of
the drill bit. At higher speeds, the
drill bit is likely to bend if allowed to
rotate freely without contacting the
workpiece, resulting in personal injury.
Always start drilling at low speed
and with the drill bit tip in contact
with the workpiece. At higher
speeds, the drill bit is likely to bend
if allowed to rotate freely without
contacting the workpiece, resulting in
personal injury.
Apply pressure only in direct line
with the drill bit and do not apply
excessive pressure. Drill bits can
bend causing breakage or loss of
control, resulting in personal injury.
GB/IE 31