Emptying The Water Reservoir - Zibro P 720 Bedienungsanleitung

E
AIR FLOW
You can change the direction of the air flow by adjusting the positions of the
horizontal and vertical louvers.
F

EMPTYING THE WATER RESERVOIR

In extreme circumstances it may be necessary to empty the internal water
reservoir. When the water reservoir is full, the transparent ring around the button
on the front of the device · flashes RED. To empty the water reservoir, take the
following action:
1 Do not move the device. This may cause water leakage.
2 First switch the device off and remove the plug from the socket.
Place a pan or container on the floor under the water drain ¸.
3
Remove the rubber plug from the water drain ¸ and let the water drain out
4
(± 1 litre).
Insert the rubber plug back into the water drain ¸, push the plug into the
5
socket and switch the device on. The warning signal must now be switched
off.
NOTE!
Under normal conditions, the condensed water in the airconditioner is
removed via the air outlet hose.
G
CONNECTION TO A PERMANENT DRAIN
1 First switch the device off and pull the plug out of the socket.
Place a pan or container on the ground under the water drain ¸ in order to
2
catch any remnant water.
Remove the rubber plug from the water drain ¸.
3
Slide a water drain hose (diameter: 15 mm internal) over the water drain ¸.
4
5 Lead the other end of the water drain hose to suitable place (drain/sink).
Ensure that the drain hose is not twisted or kinked. The hose must be
descending along its entire length.
4
83