Herunterladen Inhalt Inhalt Diese Seite drucken

Zibro P 720 Bedienungsanleitung Seite 79

Vorschau ausblenden Andere Handbücher für P 720:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Dehumidifying mode (yellow)
The temperature can be set between 18°C and 32°C by pressing the
buttons. The display on the remote control shows the set temperature.
Whether the desired temperature can actually be reached depends on
the ambient conditions. The room temperature remaining above the set
temperature is normal.
DEHUMIDIFICATION
When the dehumidification mode is activated, the transparent ring around the
button on the front of the device · turns YELLOW.
The dehumidification function can be used in different ways.
1) All models:
Only connect the air exhaust hose µ to the air outlet ¿ and lead it outside, as
when using the device in the cooling function with a single hose. Place the hose in
such a way that the hot air is expelled outside. The device will then dehumidify
the air in the room and remove excess moisture through the air hose.
2) All models:
Do not connect both the air supply ¾ and the air exhaust hose µ. Remove the
rubber plug from the water drain ¸ and ensure that the water that is removed
(e.g. through a drain hole in the floor). You can also connect a water hose to the
water drain (see chapter G).
3) PH733:
Connect the supplied water hose to the plug
Lead the other end to a drain or sink and insert the plug
µ. Do not connect both the air supply ¾ and the air exhaust hose µ. The
condensed water will be removed through the hose. The maximum rise may be
1.5 m from the floor on which the device is standing. Exceeding this distance may
damage the machine or cause leaks.
During the dehumidification, the ventilator speed
speed changes automatically to medium. The
ATTENTION!
In the automatic mode, the condensed moisture is always removed
through the air exhaust hose µ. Removing the rubber plug from the
water drain ¸ will allow the water to drain out at this point. The water
drain ¹ can not be used.
When the device is not being used in the (manual) dehumidification mode, the
must be removed from the water drain ¹.
plug
that fits into the water drain.
into the water drain
can not be adjusted. The
and
buttons are inactive.
4
79
and

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

P 729P 726Ph 733

Inhaltsverzeichnis