Emptying The Water Tank - Zibro p 95 Gebrauchsanweisung

c
oPErAtING thE AIr coNDItIoNEr
1
LED
automatically when the selected time has run down.
2
Select with this knob either low or high ventilation speed or low or strong cooling.
3
Turn this knob to maintain the temperature level in combination with cooling.
NotIcES!
The compressor has been set so that it starts functioning three minutes after the (re)start of the
G
air conditioner.
The cooling will switch off when the room temperature is lower than the set one. Ventilation
will however continue to work on the set level. When the room temperature rises above the
selected value, the cooling will work again.
D
AIr FLoW
Move the air vent directly to adjust the air flow direction of the horizontal louvres.
E

EMPtyING thE WAtEr tANK

LED lights when the water tank is full, the compressor is stopped and the fan only circulates the
air.
1
2
3
4
5
GB
40
ON/OFF and time knob "TIMER"
shows when the air conditioner is switched on (ON position). The unit switches off
Mode knob "SPEED"
Thermostat knob "THERMOSTAT"
Switch off the unit and remove the plug from the mains.
Place the water tray flat on the floor under the drain.
Remove the drain knob.
Remove the rubber plug and fill the water tray then replace the plug to stop the water flow.
Empty the tray and repeat this process until all water has been removed.
Replace the rubber plug and the drain knob, plug the unit in and switch on. LED should be
off.