Zibro P 720 Bedienungsanleitung Seite 78

Cooling mode (blue)
4
78
PLACING BATTERIES IN THE REMOTE CONTROL
Remove the battery cover by pressing the lips in and then pulling the cover
toward you. Place the new batteries as indicated (pay attention to the plus- (+)
and minus poles (-). Now replace the battery cover.
NOTE!
Use 2 AAA (1.5 Volt) batteries. Do not use rechargeable batteries.
Replace batteries with new batteries of the same type when the display
becomes fuzzy or the signal deteriorates.
1 Push the plug into the socket.
ATTENTION!
If the airconditioner does not respond to the remote control, follow the
following procedures:
• Ensure that there are batteries in the remote control.
• Ensure that the plug of the airconditioner is inserted in the socket
and switched off.
• Press the on/off switch on the front of device · and hold it down
until after the beep signal after approximately 8 seconds.
• Briefly press the on/off button of the remote control.
• The remote control is ready for use after the beep signal.
2 Press the C/F-button to set °C (Celsius) or °F (Fahrenheit).
The default setting is °C (Celsius).
3 The following functions can be selected with the mode button
remote control.
Automatic regulation of ventilator speed
Cooling;
Dehumidify;
Circulate;
Heating (PH733).
COOLING
When the cooling mode is activated, the transparent ring around the button on
the front of the device · emits a BLUE light.
The following settings are possible in the cooling mode:
• The ventilator speed can be adjusted by pressing the
Automatic regulation of ventilator speed
High
Average
Low
on the
-button