Zibro P 720 Bedienungsanleitung Seite 76

P729 and PH733 are fitted with the EVS (Effective Ventilation System) as standard.
The second hose must be attached in order to utilise this option. Attach the hose
connectors
protective grill
approximately 20-30 degrees (left or right) and then pull it towards you. Connect
the hose connector
the hose adapter
seal the gap between the window and the frame with the foam components
supplied. Cut these to size if necessary.
If use of the second hose is not possible or desired, then connecting a single hose
to the air outlet ¿ at the back of the airconditioner will suffice for the cooling
mode.
8
4
76
and the hose adapter as described above. Now remove the
from the air inlet »: First turn the protective grill
22
to the air inlet » at the back of the airconditioner. Lead
to the outside (under the hose that is already present) and
ATTENTION!
If the device is used with 2 hoses, it may fall into a different Energy
Efficiency Class. Refer to the technical specifications in this manual.
However, using a second hose as described can have a positive effect on
the energy balance in the room where the device is placed.
ATTENTION!
If the device is used with 1 hose, the protective grill
fitted to the air inlet » at the back of the device.
Keep windows and outside doors closed as much as possible in order to
prevent the inflow of exterior air. The air that is intended to enter the room
(specifically during the use of a single hose) in order to allow the
airconditioner to function correctly must always be as cool as possible.
Leading this air through a passage or adjacent room increases the comfort
level.
TIP!
When the device is in use in the cooling mode with two air hoses, it is
prudent to lead the hoses to the outside (e.g. through a window) on the
shadow side of the building. This will cool the air that is sucked in as
much as possible. In the heating mode, the air hoses can be led out of
the building on the sunny side. The expelled air is then as warm as
possible.
must always be
22