Adjusting The Timer - Zibro P 720 Bedienungsanleitung

Fan mode (green)
Heating mode (red)
Cooling
25°C
Dehumidify
18°C
Heat
4
80
CIRCULATION
When the air circulation mode is switched on, the transparent ring around the
button on the front of the device · emits GREEN light. In this mode, the air is
circulated and filtered but not cooled, dehumidified or heated. In this mode, only
the ventilator speed can be adjusted by pressing the
Automatic regulation of ventilator speed
High
Medium
Low
HEATING MODE (PH733)
When the heating mode is activated, the transparent ring around the button on
the front of the device · emits a RED light.
The heating mode of this device works on the heat pump principle. This makes it
more efficient than a normal electric heater. The heating mode can only be
activated when the ambient temperature is below 27 °C. Depending on the
outside temperature, the device will stop heating regularly in order to thaw ice
that has accumulated. The lower the outside temperature, the more frequently
this will occur. The transparent ring on the front of the device will flash
RED/ORAGNE/GREEN while this is taking place. In this mode, the desired
temperature can be set between 18 and 27°C.
When the device is in heating mode, both air hoses must be connected and led
outside.
AUTOMATIC
In the automatic mode
the ambient temperature. When the temperature in the room changes, the mode
changes automatically in order to maintain the desired temperature as accurately
as possible. The ventilator speed also adjusts automatically. The colour of the
transparent ring around the button on the front of the device · will change
depending on the mode.
NOTE!
• To prevent damage to the device, changing from the cooling or
dehumidification mode (or the reverse) takes two to three minutes.
• Negative ions are generated in every operating mode (automatic,
cooling, dehumidification, circulation and heating). (P726/P729/PH733)
4

ADJUSTING THE TIMER

You can use the timer function to set in advance when the airconditioner is to
switch on or off.
Switching off
The timer OFF function can be set when the airconditioner is switched on:
• Press
• Set the number of hours desired (1-12) with the aid of
• Press
, the device will cool, dehumidify or heat depending on
-button:
and