Adjusting The Timer; Adjusting The Clock - Zibro PX 738 Bedienungsanleitung

All manuals and user guides at all-guides.com
4

ADJUSTING THE TIMER

You can use the timer function to set in advance when the airconditioner is to
switch on or off.
Switching off
The timer OFF function can be set when the airconditioner is switched on:
• Press
• Set the number of hours desired (1-12) with the aid of
• Press
Switching on
The timer ON function can be set when the airconditioner is switched off
(stand-by):
• Press
• Set the number of hours desired (1-12) with the aid of
• Press
You can delete the set timer function by pressing the
control.
When the set time is at "00", the timer is switched off. When the Timer
function has been set the light in the button on the front of the device will
switch on.
5

ADJUSTING THE CLOCK

Press the -button. Change the time by pressing the
When the desired time has been set, press the
to save the setting.
TIP!
The light of the display fades when the remote control has not been
used for some time. This is reactivated when you touch any button.
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The compressor will be switched off when the room temperature is
lower than the set temperature. Operation is continued in the
circulation mode. When the room temperature is higher than the set
temperature, the compressor switches on again.
ATTENTION
Avoid the remote control from getting wet. Remove it from the unit
when condensation can occur.
and
and
on the remote
and -button.
-button again in order
4
75