Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AC motor
• The mains voltage must be 220 - 240 V~.
• Extension cables up to 25 m long must have a cross-section of 1.5 mm
Connections and repair work on the electrical equipment may only be carried out by elec-
tricians.
Please provide the following information in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Engine data - type plate
Cleaning, maintenance and storage
11.
m Attention!
Pull out the mains plug before carrying out any cleaning and maintenance work! Risk of
injury from electric shock!
m Attention!
Wait until the equipment has cooled down completely! Danger of burning!
m Attention!
Always depressurise the equipment before carrying out any cleaning and maintenance
work! Danger of injury!
11.1 Cleaning
• Keep the device as free of dust and dirt as possible. Rub the device clean with a clean
cloth or blow it off with compressed air at low pressure.
• We recommend that you clean the device directly after every use.
• Clean the device at regular intervals using a damp cloth and a little soft soap. Do not use
any cleaning products or solvents; they could attack the plastic parts of the device. Make
sure that no water can penetrate the device interior.
• The hose and injection tools must be disconnected from the compressor before cleaning.
The compressor must not be cleaned with water, solvents or similar.
11.2 Storage (fig. 1, 2)
m Attention! Pull out the mains plug and ventilate the equipment and all connected
pneumatic tools. Store the compressor in such a way that it cannot be used by un-
authorised persons.
www.scheppach.com
.
2
GB | 49
Werbung
