Scheppach Air Force 4 Max Original Bedienungsanleitung Seite 42

6. Do not overload your electric tool
- They work better and more safely in the specified output range.
7. Wear suitable clothing
- Do not wear wide clothing or jewellery, which can become entangled in moving parts.
- Rubber gloves and anti-slip footwear are recommended when working outdoors.
- Tie long hair back in a hair net.
8. Do not use the cable for purposes for which it is not intended
- Do not use the cable to pull the plug out of the outlet. Protect the cable from heat, oil
and sharp edges.
9. Take care of your tools
- Keep your compressor clean in order to work well and safely.
- Follow the maintenance instructions.
- Check the connection cable of the electric tool regularly and have it replaced by a rec-
ognised specialist when damaged.
- Check extension cables regularly and replace them when damaged.
10. Pull the connector out of the socket
- When the electric tool is not in use or prior to maintenance and when replacing tools
such as saw blades, bits, milling heads.
11. Avoid inadvertent starting
- Make sure that the switch is switched off when plugging the plug into an outlet.
12. Use extension cables for outdoors
- Only use approved and appropriately identified extension cables for use outdoors.
- Only use cable reels in the unrolled state.
13. Remain attentive at all times
- Pay attention to what you are doing. Remain sensible when working. Do not use the
electric tool when you are distracted.
14. Check the electric tool for potential damage
- Protective devices or other parts with minor damage must be carefully inspected to
ensure that they function correctly and as intended prior to continued use of the electric
tool.
- Check whether the moving parts function faultlessly and do not jam or whether parts
are damaged. All parts must be correctly mounted and all conditions must be fulfilled to
ensure fault-free operation of the electric tool.
- Damaged protective devices and parts must be properly repaired or replaced by a
recognised workshop, insofar as nothing different is specified in the operating manual.
- Damaged switches must be replaced at a customer service workshop.
- Do not use any faulty or damaged connection cables.
- Do not use any electric tool on which the switch cannot be switched on and off.
15. Have your electric tool repaired by a qualified electrician
- This electric tool conforms to the applicable safety regulations. Repairs may only be
performed by an electrician using original spare parts. Otherwise accidents can occur.
42 | GB www.scheppach.com