Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Residual risks
Comply with the stipulated maintenance and safety instructions in the operating instruc-
tions.
Remain attentive at all times when working, and keep third parties at a safe distance from
your work area.
Even when the device is being used properly, there will always be certain residual hazards
that cannot be completely ruled out. The following potential hazards can arise due to the
type and design of the device:
• Unintentional starting up of the product.
• Damage to hearing if the stipulated hearing protection is not worn.
• Dirt particles, dust etc. can get irritate the eyes or face despite wearing safety goggles.
• Inhaling swirled up particles.
8. Before commissioning
• Before connecting the machine, make certain that the data on the type plate matches
with the mains power data.
• Check the device for transport damage. Report any damage immediately to the transport
company which was used to deliver the compressor.
• Install the compressor near the point of consumption.
• Avoid long air lines and supply lines (extension cables).
• Make sure that the intake air is dry and free of dust.
• The compressor may only be used outdoor briefly when the ambient conditions are dry.
• The compressor must always be kept dry and must not be left outdoors after work is
complete.
• Do not deploy the compressor in damp or wet areas.
• Operate the compressor only in suitable areas (well ventilated, ambient temperature
+5°C to 40°C). There must be no dust, acids, vapours, explosive gases or inflammable
gases in the room.
• The compressor is designed to be used in dry rooms. It is prohibited to use the compres-
sor in areas where work is conducted with sprayed water.
46 | GB
www.scheppach.com
Werbung
