Sharp MultiSync PN-M652 Installationsanweisung Seite 8

Do not connect or disconnect the power cord with wet hands.
It may cause an electric shock.
DO NOT
TOUCH
WITH WET
HANDS
Please use the power cord provided with this product. Do not exceed the
product's specified power supply voltage where it is installed. Doing so
could result in a fire or electric shock. Please refer to the power supply
voltage information in the specification.
If a power cord is not supplied with this product, please contact us. For all
other cases, please use the power cord with the plug style that matches
REQUIRED
the power socket where the product is located. The compatible power cord
corresponds to the AC voltage of the power outlet and has been approved
by, and complies with, the safety standards in the country of purchase.
This equipment is designed to be used in the condition of the power cord
connected to the earth. If the power cord is not connected to the earth, it
may cause electric shock. Please make sure the power cord is connected
to the wall outlet directly and earthed properly. Do not use a 2-pin plug
MUST BE
EARTHED
converter adapter.
For proper installation it is strongly recommended to use a trained service
person.
Failure to follow the standard installation procedures could result in
damage to the product or injury to the user or installer.
REQUIRED
Please install the product in accordance with the following information.
This product cannot be used or installed without the table top stand or
other mounting accessory for support.
When transporting, moving, or installing the product, please use as many
people as necessary (at least two) to be able to lift the product by the two
handles without causing personal injury or damage to the product.
• PN-M652, PN-P656: DO NOT use this product on the floor with the
REQUIRED
Please refer to the instructions included with the optional mounting
equipment for detailed information about attaching or removing.
Do not cover the vents on the product. Improper installation of the product
may result in damage to the product, an electric shock or fire.
4
E
WARNING
table top stand. Please use this product on a table
or with a mounting accessory for support.