MAWEK WE210003A Bedienungsanleitung Seite 16

Thank you for your confidence and purchase of this modern battery charger for
charging 12V lead batteries (acid, GEL, AGM, lead calcium as well as modern
LiFePO4 with BMS) and supply of the vehicle electrical system. This
microprocessor-controlled, high-frequency battery charger corresponds to the latest
charging technology. Please treat the unit with care and attention so that it can give
you many years of good service.
Please read these operating instructions carefully and follow the instructions
before operating the charger.
- Keep these safety instructions in a safe place.
- This appliance is not intended for use by children!
General precautions
Before using the appliance, the user must always read this manual
carefully.
Precaution against electric shocks
- Danger to life from electric shock: it is expressly forbidden to reach into the live
unit.
- To minimize the risk of damage to the plug and cable, pull on the plug instead of
the cable when switching off the charger.
- Do not disassemble the charger. Service is not necessary and repairs can only be
carried out by a qualified service centre. Incorrect reassembly may result in a risk of
electric shock or fire. If you suspect that the unit is not working correctly, unplug the
mains plug and charging leads immediately.
- To avoid the risk of electric shock, always unplug the appliance before cleaning.
The appliance is live as soon as the mains cable is plugged in, even if the appliance
is still switched off.
- If the mains cable or the charging cables are damaged, they must be
replaced.
INTRODUCTION
IMPORTANT SAFETY INSTRUCTIONS
16