Werbung
Verfügbare Sprachen
Verfügbare Sprachen
日本語
Español
Installation and setup
Before use, remove all protective parts from the robot and
docking station.
1)
Assemble the base board
2)
Set up the docking station
0.2 ft / 6 cm from the wall
The docking station automatically empties the robot
and recharges its batteries.
Installation: First, install the supplied power cable. Then place the station on a flat, hard
surface at least 6 cm (0.2ft ) from the wall. If the surface is uneven, use the base plate.
Make sure there is enough space in front and on both sides for the robot to easily return
to the dock.
3)
Connect the powercord
Note: The dock must always remain connected to power. Avoid using a power source
that can be accidentally switched off (e.g., power strip, light switch, GFCI).
Italiano
Français
4)
Deutsch
Charge the robot
English
8
Werbung
