Scheppach kw 7.0 Originalbetriebsanleitung Seite 32

Attention! Do not use the emergency stop to switch
off the saw in normal operation. Otherwise, the wear
on the drive is very high.
Work complete
• Switch off the drive on the On/Off switch or tractor.
• Wait until the saw blade has come to a complete
stop.
• Pull out the mains plug or disconnect the ignition
key.
• Observe the general maintenance information.
• Bring the swivel frame to the transport position and
secure it with the swivel frame lock.
15. Maintenance and service
m Only carry out maintenance, modification,
adjustment and cleaning work when the engine is
switched off and the mains plug is disconnected.
When operating with a Cardan shaft, always
switch off the Cardan shaft and the engine first
and remove the ignition key before carrying
out maintenance, modification, adjustment and
cleaning work.
• Store the manual with the machine.
• Keep the machine clean.
• Wear safety goggles when cleaning.
• Attention! Danger of fire due to chips in the event
the cleaning carried out is insufficient.
Before starting the maintenance or checks, clean
the work area and have suitable tools at hand and in
good condition.
Fig. 1
32 | GB
The time intervals refer to normal conditions of use.
If the machine is subject to heavy use, these times
are reduced accordingly.
Clean the machine panels, covers and control levers
with a soft, dry cloth or one that has been lightly
dampened with a neutral cleaning agent.
Do not use solvents such as alcohol or petrol, as they
can attack surfaces.
Keep oils and lubricating greases out of the reach of
unauthorised personnel. Read the instructions on the
containers carefully and follow them closely.
Avoid direct contact with the skin and rinse thorough-
ly after use.
Check the V-belt tension after the first hour of opera-
tion and every time before starting up. To do so, undo
the T-screw on the motor bracket. Press the console
down and retighten the tommy screw.
All ball bearings are lifetime lubricated. The circular
saw blade is a wearing part. Check it every time before
commissioning. Only a well-sharpened, correctly set
saw blade delivers good cutting results. Occasional
greasing of the saw blade is recommended.
If signs of wear appear in the swivel saw slit, the
swivel parts must be replaced.
Additional maintenance work with Cardan shaft
operation
Tightening the V-belt (Fig. 1)
1. Loosen the hexagon bolts and push the gearbox down
evenly. The gear unit must be adjusted parallel.
2. Tighten the hexagon bolts firmly.
www.scheppach.com