Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7
Menu guidance and explanation
FP:
View process & bal-
Daily runtime
ance sheet values
FP:
Total runtime
FP:
s. filt. clean
Outlet
Filter cleaning
Number:
backflushes
Number:
rinses
Number:
cld. filt. clns
FW:
Daily runtime
FW:
Total runtime
Water level
Drain lowering
Adjust
Set
filter pump
parameters
Filter cleaning
settings
Refilling
settings
Lowering
settings
Prog. output 1
settings
Prog. output 2
settings
BEHNCKE Level Control / Menu guidance and explanation
NOTE
The menu items marked in orange are only visible or editable after the
craftsman level has been activated (see p.13).
h
h
h
time switch
Operating mode
Runtime:
s
Backflushing
Block time:
s
Filter pump
Manual:
Filter cleaning
Start:
:
Release time
Stop:
:
Release time
Max:
mins
runtime
Max:
mins
Daily runtime
Start:
:
Forced channel
Stop:
:
Forced channel
time switch
Daily filter pump runtime
Displays the daily runtime of the filter pump in hours.
Total filter pump runtime
Shows the total runtime of the filter pump in hours.
Filter pump time since filter cleaning
Shows how much time has elapsed since the last backflush.
Filter cleaning process
Shows the remaining filter cleaning time (only visible during filter cleaning)
Number of backflushes
Shows the number of backwashes.
Number of rinses
Shows the number of rinses.
Number of cancelled filter cleanings
Shows the number of cancelled filter cleanings.
Daily fresh water runtime
Shows the daily runtime of the fresh water supply in hours.
Total fresh water runtime
Shows the total runtime of the fresh water supply in hours.
Drain lowering
Displays the remaining lowering time (only visible during lowering)
Time and duration of filter runtime
Set the filter runtime using the following modes: "Same every day", "extra every day",
"Mon-Fri & Sat-Sun". You can set 3 switching times in each case.
After selecting the desired mode, you can select the time and the desired function in
the following menus: Enter "On", "Off" or "via FD" (floor drain).
Setting the time mode
Select the filter cleaning mode: "time switch" or "runtime".
Runtime: Start and stop at a specified time, daily
Time switch Here you can set a start and stop time for each day of the week in the
following menus and an interval ("every week", "14 days" or "four weeks").
Setting "—:—" disables backflushing that day.
Backflush runtime
Set the backflush time in seconds.
Backflush runtime
Here, a delay can be set for the filter pump in order to allow the valve to switch
beforehand and to avoid pressure impacts in the line.
Manual filter cleaning
Here, a filter cleaning can be triggered independently of the set times by switching to
"Yes" and confirming.
Launch the release window
Setting the earliest time when the water level may be replenished.
Release window end
Setting the latest time by which the water level must be replenished.
Maximum runtime
Setting the maximum permissible fresh water runtime
Setting range: 0 (monitoring off) – 200min.
Maximum daily runtime
Setting the maximum permissible fresh water runtime relative to one day
Setting range: 0 (monitoring off) – 600min.
Start time for forced channel
Input the time when operation with overflow channel should start.
Stop time for forced channel
Input the time when operation with overflow channel should end
Time and duration of programmable output 1
Set programmable output 1 via the following modes: "Same every day", "extra every
day", "Mon-Fri & Sat-Sun". After selecting the desired mode, you can select the time and
the desired function in the following menus: Enter "On" or "Off".
Programmable output 2
See programmable output 1.
12
Werbung
