Parkside PEKSG 85 D4 Bedienungs- Und Sicherheitshinweise Seite 14

CAUTION! Risk of injury!
m
When working with the saw
chain: Wear cut-resistant
protective gloves and, if
necessary, an apron to prevent
cuts.
CAUTION! Risk of injury!
m
l ays s it h o the produ t
and re ove the ains plu
before cleaning, carrying out
any adjustments, maintenance
or repair work.
NOTE
The product is powered by
u
an electric motor with thermal
protection and restart stop for
additional safety.
The sharpening angle can be
u
adjusted from –35° to +35°.
he hain uide rail
u
variably adjustable stop.
Sharpening is carried out by
u
s ivellin the rindin head
˜ S
CAUTION! Risk of injury!
m
he rindin dis
u
even after the product has been
s it hed o
e ore arryin out the rst
u
grinding procedure and after
every replacement of the grinding
dis : Always carry out a trial
[ ]
run o at least
without load.
14 GB
[ ]
has a
7 ] [
.
2 ] [
still runs
[ ]
se onds duration
CAUTION! Risk of injury!
m
S it h o the produ t i
u
if:
the rindin dis
–
rotating smoothly
considerable vibration occurs
–
you hear abnormal noises
–
Make sure that the mains supply
u
voltage matches the voltage rating
indicated on the product's type
plate.
NOTE
When working under dust-prone
u
conditions: Ensure that the
ventilation holes
"Cleaning and maintenance").
1. Connect the product to the mains
supply.
2. S it hin on Press the on o
s it h into the I position he
1 ] [
product starts up.
3. S it hin o Press the on o
s it h into the 0 position he
[ 1 ]
produ t s it hes o
Thermal protection with restart stop
If the product automatically shuts
down due to overuse: The product
does not restart automatically.
Switch on the product again.
˜ Sharpening the saw chain
CAUTION! Risk of injury!
m
An incorrectly sharpened saw
u
chain can cause damage and
increases the danger of saw
kickback! Ensure the saw chain is
precisely aligned.
Observe the correct sharpening
u
angle and saw chain minimum
dimensions.
ediately
is not
[ ]
are clear (see
[ ]