Parkside PEKSG 85 D4 Bedienungs- Und Sicherheitshinweise Seite 15

CAUTION! Risk of injury!
m
Remove as little material as
u
possible.
Do not grind into driving links or
u
connecting links. Otherwise the
saw chain may break.
If this is not observed, there is a
u
risk of injuries when working with
the product.
NOTE
Clean the saw chain before
u
sharpening. Remove oily wood or
oil residues with a brush or cloth.
After sharpening: All the cutting
u
links must have the same length
and breadth.
hen only around
u
uttin tooth
[
chain has become worn down and
must be replaced with a new saw
chain.
Inserting the saw chain
i step 1
1. penin the hain uide rail
the tension lever
direction:
Return the tension lever to its initial
–
position several times.
Releasing the tension lever: Pull
–
the tension lever outwards.
Let the tension lever return to its
–
original position.
Allow the tension lever to
–
reengage.
2. Place the saw chain into the chain
guide rail . The cutting edges must
7 ] [
face the grinding discs
3. old the stop
[
back the saw chain until the cutting
tooth to be sharpened rests on
[ ]
the stop.
o the
remains: The saw
]
: Turn
7 ] [
in anti-clockwise
[ ]
.
[ ]
down and pull
]
Adjusting the working angle
1. ns re the ad ustin nut
the scale to adjust the required
[ ]
sharpenin an le on the rotary
plate of the chain tensioning unit
ollo the instru tions o the sa
chain manufacturer regarding the
required sharpening angle
2. eti hten the ad ustin nut
Adjusting the stop
i step
1. Move the grinding head
handgrip downwards.
4 [
2. Use the adjusting screw for the chain
eed to bring the cutting tooth
[ ]
closer to the grinding disc
cutting tooth has to be in contact
with the grinding disc.
3. Se urin the ad ustin s re
the ad ustin nut
4. i in the hain links in the hain
guide rail : Turn the tension
[ 7 ]
lever in clockwise direction.
[ ]
5. se the ad ustin s re
the depth stop. The grinding disc
has to touch the base of the tooth.
6. Secure the grinding depth with the
ad ustin nut
[
Sharpening
1. Switch on the product (see
S it hin on o ).
2. Press the handgrip
to move the grinding head
downwards and sharpen the cutting
tooth . The grinding disc
[ ]
not be brought to a standstill with the
brakes. Reduce the pressure in good
time to avoid this.
3. Sharpen the teeth on one side of the
saw chain.
4. Adjust the sharpening angle and
sharpen the teeth on the other side
of the saw chain.
. Use
9 ] [
[
.
9 ] [
on the
2 ] [
[
. The
[ ]
: Use
[ ]
.
[ ]
to adjust
[ ]
[
.
]
gently
[ 4 ]
[ 2 ]
must
[ ]
GB
.
]
]
]
15