Parkside PEKSG 85 D4 Bedienungs- Und Sicherheitshinweise Seite 12

The outside diameter and
thickness of the attachment
tool must correspond to the
dimensions indicated for your
power tool. Attachment tools which
are wrongly dimensioned cannot be
su iently shielded or controlled.
T
of your power tool precisely.
isks that do not t the rindin
spindle precisely rotate unevenly,
vibrate sharply and can lead to loss
of control.
Wear personal protective
D
application, use full face shields,
eye protection or safety goggles.
In so far as it is appropriate,
wear dust masks, ear protection,
gloves or special aprons which
keep small grinding and material
particles away from you. Eye
protection must be worn to protect
a ainst orei n atter yin around
during the various applications.
Dust or breathing masks should
lter the dust that is reated durin
operation. If you are exposed to loud
noise or a lon ti e you ay su er
hearing loss.
Ensure that other people are at
a safe distance to your working
area. Anyone who enters the
working area should wear
Broken bits from the piece being
worked or broken attachment tools
an y a ay and ause in uries even
beyond the direct working area.
Keep the connection cable away
from the rotating attachment tool.
If you lose control of the device,
the connection cable can become
separated or caught and your
hand or arm may be pulled into the
rotating attachment tool.
12 GB
Clean the ventilation slits of
your power tool routinely. The
motor air pulls dust into the
housing and, should too much
metallic dust collect, could cause
electrical hazards.
Never use the power tool near
power tool when it is standing on a
Sparks could ignite this material.
Do not use attachment tools which
or another coolant could lead to
electrical shock.
Keep the mains cable and extension
cable away from the grinding disc.
In the event that it is damaged or
severed, immediately disconnect
the plug from the socket. Do not
touch the cable before it has been
disconnected from the mains. Risk of
electric shock.
The replacement of the plug or the
connection line must always be
executed by the manufacturer of
the electric tool or his/her customer
service in order to avoid any hazards.
˜ Assembly
NOTE
l ays the produ t ith the
u
supplied s re s
e ore the initial start up i the
u
product securely to a worktop.
nsure that you have su
u
space in which to work. Do not
endanger other people.
Maintaining control of the product:
u
Always fasten the product onto the
orktop ith s re s o su
length and thickness.
N
Using water
1 7
ient
ient