ECOFOREST ecoGEO Benutzerhandbuch Seite 53

Boiler
State

RealT:
Regulation:
hiller
Status:
RealTemp:
Regulation:
Outdoor temperature
OutdoorT:
47
Outdoor StopT
Heating:
Active cool:
Passive cool:
Room terminals
Tset Treal
47  
Z:  9
Z:  95
Z3: 3 
Z4:  3
Z5: 5 7
XXXXX buffer tank
RealT:
SetpointT:
DTstart:
XXXXXX groups
SetT RealT
 
DG: 5 498
SG: 45 4
SG3: 45 43
SG4: 35 35
DHW
RealT:
3
SetT:
DTstart:
94
Start comp T:
DHW recirculation
State:
RealT:
SetT:
DTstart:
Boiler
Off
This displays the On/Off status of the boiler, current temperature in the water sensor
4 beneath the boiler, and the boiler input percentage.
%
Chiller
Off
This displays the On/Off status of the chiller, current temperature in the water sensor
beneath the chiller, and the chiller input percentage.

%
Outside temperature
47
This displays the current outside temperature and the outside temperatures for heating
and cooling cut-off.

8
3
Interior terminals
RH
%
In installations with indoor terminals equipped with bus communication (Th-T or TH
3
sensors), it displays the indoor setpoint temperature (Tcons), the current temperature
33
9
(Treal) and the current relative humidity (HR) of the terminals assigned to each outlet
34
44
unit.
Heating buffer / Cooling buffer
This displays the setpoint temperature, the start-up temperature differential and the
499
current temperature of the buffer storage tank.
5
Note: There are separate screens for the heating and cooling buffer storage tanks.
5
Note: If the icon (MAX) is displayed above the actual temperature, it indicates that an
operating limit of the heat pump has been reached and has been not possible to reach the
established setpoint or has not been possible to reach without using auxiliary equipment.
This condition modifies the general starting up criteria of the heat pump so that it might
not start despite there being demand in the service.
Heating units / Cooling units
Reg
%
This displays the target outlet temperature (Tcons), the current outlet temperature
 (Treal) and the regulation percentage (Reg) of each outlet unit.
3
94
Note: There are separate screens for the heating and cooling outlet units.
DHW Tank
479
This displays the setpoint temperature, the start-up temperature differential and the
48 current temperature of the DHW storage tank.
5
Note: If the icon (MAX) is displayed above the actual temperature, it indicates that an
43
operating limit of the heat pump has been reached and has been not possible to reach the
established setpoint or has not been possible to reach without using auxiliary equipment.
This condition modifies the general starting up criteria of the heat pump so that it might
not start despite there being demand in the service.
DHW Recirculation
ON
This displays the setpoint temperature, the start-up temperature differential and the
479 current temperature of the DHW recirculation.
48
5
53
User manual