Parkside Performance PPTSA 20-Li C3 Originalbetriebsanleitung Seite 50

3. To set a mitre angle of 1 or
the adjusting knob
4. Tighten the wing screws
5. Hold the product rmly ith both
hands during the angle cut to maintain
better control of the product.
˜ Adjusting the cutting depth
Fig A
1. Press and hold the locking
mechanism of the cutting depth
[ ]
adjustment.
2. Set the desired cutting depth on the
cutting depth scale
reference mark
[
A: Mark ithout guide rail
B: Mark ith guide rail
3. Release the locking mechanism
˜ Guide rail
Fig A F
B
NOTE
The guide rail
u [
guard black rubber lip at the
bottom.
Shorten the anti-splinter guard so that it is
ush ith the length of the guide rail
To do so proceed as follo s
1. Place the guide rail
2. Set a cutting depth of appro 10 mm
on the product (see "Adjusting the
cutting depth"
3. Switch the product on (see "Switching
on o "
4. Guide the product evenly in the cutting
direction, applying slight pressure.
48 GB/IE
turn
after swivelling.
[ ]
again.
[ 7 ]
based on the
[ ]
.
]
[ ]
[ ]
.
[ ]
has an anti-splinter
]
.
[ ]
on a workpiece.
[ ]
Connecting the guide rail
1. Slide the connecting element
the groove on both parts of the guide
rail .
[ ]
The connecting element should be in
the middle between both parts of the
guide rail.
2. Tighten the grub screws
small hex key
[
˜ Operation
˜ Inserting/removing the
battery pack
WARNING! Risk of injury due to
m
unintentional start-up!
Only insert the battery pack
u
the product is fully prepared for use.
NOTICE! Risk of property damage
m
and damage to the product!
An incorrect battery pack can
u
damage the product and the battery
pack.
Inserting the battery pack
1. Push the battery pack
guide rail into the product.
9 ] [
2. Ensure the battery pack
audibly in place.
Removing the battery pack
1. Press and hold the release button
on the battery pack
2. Remove the battery pack
product.
˜ Setting the speed and
ECO
Press to set one of the speed
[ ]
o
levels.
An ECO mode is also available.
o
lights up when the ECO
[ ]
mode is active.
into
[ ]
with the
[ ]
.
]
once
[ ]
along the
[ ]
clicks
[ ]
[
.
[ ]
from the
[ ]
]