Adjusting The Cutting And Mitre Angle; "Adjusting The Cutting Depth; Guide Rail; Checking The Charging Level Of The Battery Pack On The Product - Parkside Performance Pptsa 20-Li C3 Originalbetriebsanleitung

˜ S i i
Switching on
1. Push the switch lock
2. Press the on o s itch
Once the product starts running, you
can release the switch lock
3. Plunge the sa blade
workpiece.
S i i
1. Release the on o s itch
2. Guide the sa blade
guard cover .
[ ]
˜ Checking the charging level
of the battery pack on the
product
The charging level of the battery
o
pack is indicated by illumination
[ ]
of the corresponding LEDs on the
charging level indicator
During operation, the charging level
o
of the battery pack
displayed on the charging level
indicator .
[ ]
Colour
Red, orange, green Fully charged
Red, orange
Red
Charge the battery pack
o
only the red LED on the charging level
indicator is illuminated.
[ ]
˜ Working instructions
NOTE
The cutting width markings
u
the guard cover
and rear cutting point of the saw
blade 1 0 mm at maximum
[ ]
cutting depth.
forward.
3 ] [
.
[ 5 ]
.
3 ] [
into the
[ ]
.
[ 5 ]
back into the
[ ]
.
[ ]
is permanently
[ ]
M i
Half charged
Needs to be
charged
when
[ ]
on
[ ]
show the front
[ ]
˜ Sawing without guide rail
Right-angled sawing
1. Hold the product ith both hands one
hand on the handle
hand on the auxiliary handle
2. Switch on the product (see "Switching
on o "
3. Place the product with the front part of
the saw table
[
4. Plunge the sa blade
workpiece. Saw forward with moderate
pressure – never backward.
Mi
1. Set the desired cutting angle (see
"Adjusting the cutting and mitre
angle"
2. Hold the product ith both hands one
hand on the handle
hand on the auxiliary handle
3. Switch on the product (see "Switching
on o "
4. Place the product with the front part of
the saw table
[
5. Plunge the sa blade
workpiece. Saw forward with moderate
pressure – never backward.
Plunge cuts
NOTE
Reduce the risk of kickback by
u
placing the rear edge against a stop
e g the guide rail
Moving sideways during the cut
u
can cause the sa blade
resulting in kickback. When making
plunge cuts that are not made at a
right angle secure the sa table
against moving sideways.
1. Set the desired cutting depth (see
"Adjusting the cutting depth"
2. Place the product on the workpiece.
and the other
[ 6 ]
.
[ 1 ]
on the workpiece.
]
into the
[ ]
and the other
[ 6 ]
.
[ 1 ]
on the workpiece.
]
into the
[ ]
[ ]
to jam,
[ ]
[
GB/IE
]
49