Sawing With Guide Rail; Overload Warning; Cleaning, Maintenance And Storage; Maintenance - Parkside Performance Pptsa 20-Li C3 Originalbetriebsanleitung

3. Hold the product ith both hands one
hand on the handle
hand on the auxiliary handle
4. Switch on the product (see "Switching
on o "
5. Plunge the sa blade
workpiece. Saw forward with moderate
pressure – never backward.
˜ Sawing with guide rail
Right-angled sawing
1. Place the guide rail
workpiece with the black rubber lip
facing downwards.
2. Place the product with the groove onto
the guide rail
[
3. Hold the product ith both hands one
hand on the handle
hand on the auxiliary handle
4. Switch on the product (see "Switching
on o "
5. Plunge the sa blade
workpiece. Saw forward with moderate
pressure – never backward.
Mi
1. Place the guide rail
workpiece with the black rubber lip
facing downwards.
2. Place the product with the groove onto
the guide rail
[
3. Set the desired cutting angle (see
"Adjusting the cutting and mitre
angle"
4. Hold the product ith both hands one
hand on the handle
hand on the auxiliary handle
5. Switch on the product (see "Switching
on o "
6. Plunge the sa blade
workpiece. Saw forward with moderate
pressure – never backward.
Plunge cuts
1. Place the guide rail
workpiece with the black rubber lip
facing downwards.
50 GB/IE
and the other
6 ] [
.
1 ] [
into the
[ ]
on the
[ ]
.
]
and the other
[ 6 ]
.
1 ] [
into the
[ ]
on the
[ ]
.
]
and the other
[ 6 ]
.
1 ] [
into the
[ ]
on the
[ ]
2. Place the product with the groove onto
the guide rail
[
3. Set the desired cutting depth (see
"Adjusting the cutting depth"
4. Place the rear edge of the saw table
as far as possible against a stop.
5. If necessary improve the tting
accuracy of the sa table
the guide rail
[
screws . Tighten the eccentric
8 ] [
screws to minimise the play between
the product and the guide rail.
6. Hold the product ith both hands one
hand on the handle
hand on the auxiliary handle
7. Switch on the product (see "Switching
on o "
8. Plunge the sa blade
workpiece. Saw forward with moderate
pressure – never backward.
˜ Overload warning
If the product is in danger of being
damaged, lights up brie y The
[ ]
product s itches o
˜ Cleaning, maintenance and

storage

WARNING! Risk of injury!
m
Protect yourself when performing
u
maintenance or cleaning work.
S itch o the product and remove
u
the battery pack
Have any repair and maintenance
o
work that is not described in these
instructions carried out by our Service
Centre see "Service" Only use
original replacement parts.
.
]
in
[ ]
with the eccentric
]
and the other
6 ] [
.
1 ] [
into the
[ ]
.
[ ]
[ ]