Tips For The Mowing Process; Storage And Maintenance - Fuxtec Fx-Rme43 Bedienungsanleitung

34. Tips for the mowing process

Start mowing as close to the socket as possible.
-
Always keep the extension cord on the section of lawn that has already been mowed.
-
Maintain a constant cutting height of 3-5 cm; Do not trim the grass to less than half of its original
-
height.
Do not overload the lawnmower! If the engine speed drops noticeably due to long, heavy grass,
-
increase the cutting height and mow several times.
Mow in the morning or late afternoon to prevent the freshly cut grass from drying out.
-
Mow twice a week during periods of strong growth; In periods of low precipitation, extend the
-
mowing intervals accordingly.

35. Storage and maintenance

Replacement of the blade
For safety reasons, you should only have your knife sharpened, balanced and assembled in an authorized
workshop. For best results, it is recommended to check the knife once a year.
WARNING! Before removing the grass collector, turn off the motor and wait for the blade to come
to a complete stop.
WARNING! You will need gardening gloves (not included) and a wrench to remove the blade.
HINT! Tilt the lawn mower slightly towards the oil filler neck without tipping it over and reach under
the housing.
WARNING! Always handle the knife with care; sharp edges can cause injury. Use gloves. Replace the
metal blade after 50 hours of mowing or at the latest after 2 years, whichever comes earlier,
regardless of the condition.
WARNING! If the knife is cracked or damaged, replace it with a new one.
WARNING! Do not hold the knife directly with your hand.
HINT! Keep the blade sharp to maintain mowing performance. If the knife is badly worn, dented or
dull, it should be replaced or sharpened. The sharpness of the blade significantly affects the
performance of the lawn mower.
For safety reasons, we recommend that the knife should only be used by qualified and authorized
professionals.
Hold the knife firmly and screw the knife screw against the knife screw with a wrench
Clockwise. Remove the knife. Install a new or sharpened knife. Set
Attach the knife to the two pins on the knife flange and replace the screw. Make sure that
the knife is correctly positioned and tighten the screw firmly (tightening torque: 45-60 Nm).
Storage
Fig. 16
Always disconnect the machine from the power supply for storage.
Clean the appliance thoroughly after mowing. Store the device in a dry place so that the engine can cool
36