Adjusting The Cutting Height - Fuxtec Fx-Rme43 Bedienungsanleitung

Hang the collection bag as shown in Fig. 5b.
-
Fig. 5a
Front-
(3
)
(3
)
Clean up the connection cable
Attach the connection cable to the handle using the cable clips (Fig. 6).
Fig. 6

26. Adjusting the cutting height

CAUTION! If the motor has been switched off, the saw blade will continue to run for a few seconds!
Therefore, do not touch the underside of the mower deck until the blade has come to a stop!
If you want to change the cutting height, set the adjustment lever to the desired position. (Fig. 7).
Slide the handle to the outside of the deck body (1).
Adjust the handle to the desired height (2). The mower has 6 height positions from 25 mm to 75 mm. As
the number increases, the cutting height increases.
Back
(2) (2)
(3
)
(1)
(2)
32
Fig. 5b