Before You Begin - HP Officejet 9100 Leitfaden Zur Inbetriebnahme

Before you begin

1. Before setting security options, obtain the following information:
• DNS and NetBIOS domain names
For example, if you are using Active Directory 2003 and the domain is set to
"sales.mycompany.com", then the full DNS domain name would be
"sales.mycompany.com" and the NetBIOS domain name would be "sales".
• LM authentication settings (if the default settings on the server or domain have
been modified)
CAUTION: If the LM authentication setting on the all-in-one does not match the setting on the
server, activities that require login (such as network folder activities) might not function.
2. If you have recently changed the DNS or WINS settings, turn off and then turn on
the all-in-one.
To set the security level
EWS (recommended)
1. Open the EWS.
2. Click the Settings tab, and then click Security in the left pane.
3. Select the desired security setting from the Device access level list.
PIN
a. Select PIN, and then set a PIN number.
b. Click the Users PIN tab and configure the appropriate settings, as needed.
Windows NT
a. Select Windows NT, and then enter the Windows NT domain (both DNS and NetBIOS
domains) and password information.
b. Click the Administrators and Windows NT Login Access tabs and configure the
appropriate settings, as needed.
c. If LM authentication is enabled in the server, select Network Folder in the left pane,
and then configure the LM authentication setting to match the setting used on the server.
4. Click Apply.
All-in-one control panel
1. At the control panel, press the M
2. Press (down) to move to Admin, and then press
3. Press (down) to move to ADMIN SETUP, and then press
4. Press (down) to move to Device access, use the – or + to select the desired
security setting, and then press
PIN
a. Select PIN, and then follow the instructions on the display to set a PIN number.
ove to
b. M Registered users and configure the appropriate settings, as needed.
Windows NT
a. Select WinNT, and then enter the Windows NT domain (both DNS and NetBIOS
domains) and password information.
b. Select Administrators and WinNT login access and configure the appropriate
settings, as needed.
c. If LM authentication is enabled in the server, select LM authentication, and then
configure the LM authentication setting to match the setting used on the server.
5. Once these settings are configured, the all-in-one returns to the Ready state.
button.
ENU
(select).
(select).
Setting up the digital send authentication solution
(select).
9