HP Officejet 9100 Leitfaden Zur Inbetriebnahme Seite 8

9. Reattach the power cord and any cables, and then press
10. Print a configuration page and check the DIMM slot entries in the Device Information section
to verify that the DIMM is installed. If installed properly, the DIMM should be listed as
"Digital Send Authentication Solution".
NOTE: You can also verify that the DIMM is installed using the EWS. Click the Information tab,
and then click Device in the left pane.
If the DIMM is not listed on the configuration page, see "Solving DIMM installation
problems" on page 10.
Step 4: Configure the security settings
After the DIMM is installed, set the security level for the all-in-one. You can enter these settings
using either the EWS (recommended) or the control panel.
Types of security
The digital send authentication solution offers two types of security: PIN and Windows NT.
These security settings require all-in-one users to log in for some or all control panel activities and
restrict access to the ADMIN and NETWORK & I/O menus in the control panel.
NOTE: Windows NT security supports Windows NT 4.0, Windows 2000, Windows XP, and
Windows 2003 environments.
Table 1-1 Description of security settings
Access point
Control panel
activities
LCD ADMIN
menu access
NETWORK &
I/O menu access
a.With the Windows NT security option, the administrator can designate additional all-in-one
administrators.
8 Setting up
Security type
PIN security
Users must enter their PINs for all
control panel activities (such as
copy, fax, and e-mail activities).
Access to these menus is restricted.
An administrator PIN is required.
(Power) to turn on the all-in-one.
Windows NT security
Users must perform Windows NT
login for:
• Only e-mail and network folder
activities.
-OR-
• All control panel activities.
Access to these menus is restricted.
Only the administrator or
designated all-in-one
a
administrators can gain access.