Werbung
TROUBLE
SHOOTING/
Problem
/
Model
doesn't
move
Loss
of
Control
Doesn't
Run Straight
Doesn't
Stop
Running
Too Slowly
Instructions
for usage of
RC EP boats and yachts in Salt water.
Please read these instructions carefully before using this RC boat on
salt water in order to prevent part of your model from salt water
corrosion (and corrosion in general)
Prior to starting your boat, please check carefully the following
parts:
1 Main shaft lubrication. Lubrication on this part of your boat prevents
ware and also ensures minimal water penetration.
2.Check the rubber seals on your linkages to ensure again that there
are no water penetration issues and apply some grease if necessary
to assist prevention
3.Check carefully your electronics compartment and insure proper
seal on the cover.
Ensure
that surfaces
with the enclosed tape, making sure there are no wrinkles or gaps on
the tape that might allow water to insert this compartment.
4.We highly suggest using an anticorrosive
After Using your Boat, please follow the instructions below
1.Turn your main switch off and do not open yet any of the sealed
compartments. With a sponge and tap water rinse the boat from salt
water so that it does not corrode any of the parts. In case you are not
able to wash your boat right after using it in salt water, we suggest a
good wash soonest possible after use with the assistance of some
dishwashing liquid
2. Use a towel / tissues or kitchen paper to dry thoroughly the boat
and all sealed-off compartments in order to allow any trapped
humidity to dry. Check for indication of salt water in your boat, dry
immediately and try to clean salt residues
3. Use anticorrosive spray on all the boats outer rigging and specially
on metal parts and screws in order to prevent any left salt from
damaging the parts.
! ?
Cause
/
Power
switch
On the
Hull
Or Transmitter
Transmitter
batteries
are wrong
type or wrong
There
is not enough
charge
left in Transmitter
Due to high temperature the heat protection system may be operating
Batteries
have
run
down.
There
is not enough
charge
left in Transmitter
Batteries
have
run
down.
Main road or large steel pylon
is nearby.
Rudder
Trim is not adjusted
correctly.
Throttle
Trim is not adjusted
correctly
Batteries
have
run
down.
are clean
and seal the cover
spray also prior to usage.
is not turned
ON.
Switch
power
po arity.
Check
polarity
Change
batteries
batteries
Disconnect
Change
batteries
batteries.
Change
batteries
Change
batteries
Run
model
Make
adjustment
Make
adjustment
Change
batteries
35
Correction
/
on as per Instruction
Manual
P. 17.
and type as per Instruction
Manual
as per Instruction
Manual
223
battery
connectors
and let the circuitry
as per Instruction
Manual
P.11
as per Instruction
Manual
223
as per Instruction
Manual
P.11
in
different
area
as per Instruction
Manual
219
as per Instruction
Manual
P.19
as per Instruction
Manual
P.11
P 13
coo off.
Werbung
