Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
If the outside temperature is very low, the heating capacity of
the air conditioning system may not be sufficient. We
recommend connecting additional heat sources.
Fan (Only) Mode
▶ Press the M key repeatedly until
▶ Press the
key until the required fan speed is reached.
AUTO can be selected to enable automatic control.
The temperature cannot be adjusted or displayed in fan mode.
5.4
Setting the room temperature
▶ Press the . or / key to set the desired room temperature.
The setting is applied shortly afterwards.
The temperature cannot be adjusted in Fan Mode.
5.5
Setting timer
5.5.1 One-time ON/OFF timer
▶ Press the TIMER key repeatedly until the corresponding
symbol appears.
– ON timer: ON DAY
– OFF timer: OFF DAY
– ON and OFF timer: ON+OFF DAY
▶ Confirm with key.
The clock display starts flashing.
▶ Press the . or / key to set the desired ON/OFF time.
▶ Press the key again to save the setting.
The ON/OFF timer cannot be set at a secondary wired room
controller.
5.5.2 Weekly ON/OFF timer
Setting timer
▶ Press the TIMER key until WEEK 1 appears in the display.
▶ Confirm with key.
▶ Press the . or / key to select the weekday.
▶ Confirm with key.
▶ Press the . or / key to set the desired ON time.
60
appears on the display.
▶ Confirm with key.
▶ Press the . or / key to set the desired OFF time.
▶ Confirm with key.
Up to four times can be set.
▶ Repeat procedure every subsequent day of the week.
To delete the timer for the selected day:
▶ Press the DAY OFF key.
Activating the timer
▶ Keep pressing the TIMER key until WEEK 1 appears in the
display.
The timer is now switched on. The unit is switched on or off
at the selected times and days.
Deactivating the timer
▶ Keep pressing the TIMER key until WEEK 1 disappears in
the display.
To switch off the unit when the week timer is active:
▶ Briefly press K key.
The unit switches off until the next ON timer is reached.
▶ Hold the K key pressed for two seconds to switch off the
unit and deactivate the week timer.
Programming the switch-on delay
If week timer 1 is active and the ON time is to be delayed.
▶ Select week timer 1 with TIMER key.
▶ Press the DAY OFF key 2x until 1h appears on the display.
▶ Wait for a few seconds while the setting is saved.
The unit now starts the next activity cycle following a delay
of 1 hour.
▶ Press the DAY OFF key 3x until 2h appears on the display.
The unit now starts the next activity cycle following a delay
of 2 hours.
5.5.3 Weekly event timer
Setting timer
Up to 8 events can be set for each day to change the operating
mode, temperature and fan speed.
▶ Keep pressing the TIMER key until WEEK 2 appears in the
display.
▶ Confirm with key.
▶ Press the . or / key to select the weekday.
▶ Confirm with key.
Climate Room Control – 6721841498 (2023/04)
Werbung
