Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pos
Symbo
Explanation
.
l
2
Display of temperature and status
Value display: shows the current fan speed.
There are several output stages (bars) and the
AUTO setting for automatic control
Value display: indicates the set temperature as
standard.
Infographic: keylock
Infographic: appliance 1/2
Infographic: Turbo cool/Turbo heat is active.
Infographic: room temperature
Infographic: automatic rotation is active.
Infographic: Follow me active.
Infographic: automatic swing function is active
(up/down or left/right).
3
Time display
Value display: indicates time.
4
Timer display
Infographic: timer On/Off
Infographic: weekdays active
Infographic: day
Infographic: week
Table 30 Symbols in the display
5.2
Setting the day and time
▶ Press the TIMER key until the timer display starts flashing.
▶ Select the current day with the . and / keys. The selected
day flashes.
▶ Press the TIMER or key to confirm the entry.
The selection jumps to the time.
▶ Press or hold the . or / key to set the time.
▶ Press the TIMER or key to confirm the entry.
To toggle between 12- and 24-hour display:
▶ Press/keep the TIMER and DAY OFF keys pressed
simultaneously for several seconds.
5.3
Setting main operating mode
Depending on the indoor unit and configuration of the wired
room controller, not all operating modes may be available.
Turn unit on/off
▶ Press the K key to switch the device on or off:
The unit starts in the set operating mode or switches off. To
protect the unit it can only be switched back on after some
time has passed.
Climate Room Control – 6721841498 (2023/04)
Settings can also be made when the appliance is switched off.
The device saves the settings, and also retains them in the
event of a power failure.
After it has been switched off, the unit remains in standby
mode. An automatic energy saving mode is enabled in standby
mode due to intelligent On/Off technology (1 W standby).
Following a power failure the unit restarts automatically. This
can lead to conflicting readings on the displays which are
resolved automatically during operation.
Automatic mode
In automatic mode, the unit switches automatically between
heating, cooling, fan and dehumidification mode, depending
on the set temperature.
▶ Press the M key repeatedly until
display.
▶ Press the . or / key to set the required temperature.
The fan speed cannot be adjusted in automatic mode.
Cooling mode
▶ Press the M key repeatedly until
▶ Press the
key until the required air speed is reached.
▶ Press the . or / key to set the required temperature.
Dehumidification mode
▶ Press the M key repeatedly until
▶ Press the . or / key to set the required temperature.
The fan speed cannot be adjusted in dehumidification mode.
Heating mode
▶ Press the M key until
▶ Press the . or / key to set the required temperature.
▶ Press the
key until the required air speed is reached.
Operation
appears on the
appears on the display.
appears on the display.
appears on the display.
59
Werbung
