Microlife BP W1 Basic Bedienungsanleitung Seite 10


Always remove the rechargeable batteries if you do not intend
to use the device for a week or more.

Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.
8. Error messages
Error Description Potential cause and remedy
«ERR 1» Signal too
The pulse signals on the cuff are too
weak weak. Re-position the cuff and repeat the
measurement.*
«ERR 2» Error signal During the measurement, error signals
were detected by the cuff, caused for
AP
instance by movement or muscle tension.
Repeat the measurement, keeping your
arm still.
«ERR 3»
No pressure An adequate pressure cannot be gener-
in the cuff ated in the cuff. A leak may have
AQ
occurred. Check that the cuff is correctly
connected and is not too loose. Replace
the batteries if necessary. Repeat the
measurement.
8
Error Description Potential cause and remedy
«ERR 5» Abnormal The measuring signals are inaccurate
result and no result can therefore be displayed.
Read through the checklist for taking a
reliable measurement and then repeat
the measurement.*
«HI» Pulse or cuff The pressure in the cuff is too high (over
pressure too 299 mmHg) OR the pulse is too high
high (over 200 beats per minute). Relax for 5
minutes and repeat the measurement.*
«LO» Pulse too The pulse is too low (less than 40 beats
low per minute). Repeat the measurement.*
9. Safety, care, accuracy test and disposal
Safety and protection
 Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device
and keep for future reference.