Safety Rules - PeakTech 1125 Bedienungsanleitung

1. Introduction
This product complies with the requirements of the following
European Community Directives: 2004/108/EC (Electromagnetic
Compatibility) and 2004/22/EC (Low Voltage) as amended by
2006/95/EC (CE-Marking). Overvoltage category IV; pollution
degree: 2

2. Safety Rules

The PeakTech
However, no design can completely protect against incorrect
use. Electrical circuits are dangerous through lack of caution or
poor safety practice. The following rules should reduce the
danger:
* Read the user´s manual carefully and completely before
using the instrument. Fully understand the instructions
before using this product. Follow the instructions for every
test. Take all necessary precautions. Do not exceed the
limits of this instrument.
* The circuit to be tested must be de-engergised and isolated
before connections are made to it.
* Do not use test leads, probes or crocodiles/alligator-clips
that are dirty, damaged or have broken or cracked
insulation. Such accessories should be removed and
repaired immediately.
* Always disconnect the test leads before replacing any fuse.
®
1125 has been designed with safety in mind.
-17-