Parkside PSTDA 20-Li B3 Originalbetriebsanleitung Seite 8

IE NI
2) ELECTRICAL SAFETY
a) Power tool plugs must
match the outlet. Never
modify the plug in any
way. Do not use any
adapter plugs with
earthed (grounded) power
tools. Unmodified plugs and
matching outlets will reduce risk
of electric shock.
b) Avoid body contact with
earthed or grounded sur-
faces, such as pipes, ra-
diators, ranges and refrig-
erators. There is an increased
risk of electric shock if your
body is earthed or grounded.
c) Do not expose power tools
to rain or wet conditions.
Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord.
Never use the cord for
carrying, pulling or un-
plugging the power tool.
Keep cord away from
heat, oil, sharp edges or
moving parts. Damaged or
entangled cords increase the
risk of electric shock.
e) When operating a power
tool outdoors, use an ex-
tension cord suitable for
outdoor use. Use of a cord
suitable for outdoor use reduces
the risk of electric shock.
f) If operation of the power
tool in a damp environ-
ment is unavoidable,
please use a residual cur-
rent circuitry. The use of a
residual current circuitry reduces
the risk of an electric shock.
8
3) PERSONAL SAFETY
a) Stay alert, watch what
you are doing and use
common sense when
operating a power tool.
Do not use a power tool
while you are tired or un-
der the influence of drugs,
alcohol or medication. A
moment of inattention white op-
erating power tools may result
in serious personal injury.
b) Use personal protective
equipment. Always wear
eye protection. Protective
equipment such as dust mask,
non-skid safety shoes, hard hat,
or hearing protection used for
appropriate conditions will re-
duce personal injuries.
c) Prevent unintentional
starting. Ensure the switch
is in the off-position be-
fore connecting to power
source and/or battery
pack, picking up or carry-
ing the tool. Carrying power
tools with your finger on the
switch or energising power tools
that have the switch on invites
accidents.
d) Remove any adjusting key
or wrench before turn-
ing the power tool on. A
wrench or a key left attached to
a rotating part of the power tool
may result in personal injury.
e) Do not overreach. Keep
proper footing and bal-
ance at all times. This ena-
bles better control of the power
tool in unexpected situations.