Residual Risks; Assembly; Removing The Protective Cover; Assembling/Removing The Slide Shoe - Parkside Pstda 20-Li B3 Originalbetriebsanleitung

IE NI

Residual risks

Even if properly operating and han-
dling this electric tool, some residual
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk
of serious or lethal injuries,
we recommend that per-
sons with medical implants
consult their doctor and the
manufacturer of their medical
implant before operating the
machine.

Assembly

Only insert the battery once
the battery-operated tool is
fully ready for use.
Attaching/removing the
protective cover
Attaching the protective cover
1. Press the two holders on the protective
cover (15) into the recesses on the ap-
12
pliance housing. The protective cover
(15) locks into place.
You can fold the fitted protective
cover (15) up by 90°.

Removing the protective cover

2. Carefully press the two holders on the
protective cover (15) apart.
3. Pull the protective cover (15) to the front.
Assembling/removing
the slide shoe
When working on scratch-sensitive work-
pieces, working with the slide shoe (20) is
recommended.
Attaching the slide shoe
1. Place the shoe (20) on the front of the
bottom plate (5).
2. Now, press the notches (20a) on the
back of the slide shoe over the base-
plate (5).
Removing the slide shoe
1. Press the slide shoe (20) on the notches
(20a) from the baseplate (5).
2. Pull the slide shoe (20) forward, away
from the baseplate (5).
Removing/inserting the
rechargeable battery
1. To remove the battery (22) from the
device, press the release button (23) on
the battery and pull the battery (22) out.
2. To insert the battery (22), push the bat-
tery (22) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.