Working Instructions; Cleaning And Servicing; Cleaning; Maintenance - Parkside Pstda 20-Li B3 Originalbetriebsanleitung

IE NI

Working instructions

• Clamp the workpiece. Use a clamping
device for small workpieces.
• Draw a line to specify the direction in
which the saw blade is guided.
• Hold the device securely by the handle.
• Set the sawing speed.
• Adjust the mitre angle.
• Set the pendulum stroke position.
• Turn on the device.
• Wait until the device has reached full
speed.
• Place the bottom plate (5) on the work-
piece.
• Slowly move the device along the
marked line, pressing the bottom plate
firmly against the workpiece.
• Do not apply too much pressure to the
device. Let the device do the work.
• Before shutting down the device, switch
it off and wait for it to come to a com-
plete standstill.

Cleaning and Servicing

Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.
16

Cleaning

The device must not be
sprayed with water or placed
in water. Otherwise there is
a risk of electric shock.
Do not use any cleaning agents or
solvents. This could damage the
device irreparably. Chemical sub-
stances may attack the plastic parts
of the device.
• Keep the ventilation slits, motor housing
and handles of the machine clean.
Use a damp cloth or brush to do this.

Maintenance

The device is maintenance free.

Storage

• Always store the devices and accesso-
ries:
- dry.
- clean.
- protected against dust.
- out of the reach of children.
• Remove the rechargeable battery from
the device before storing the device
(see the separate operating instructions
for the battery and charger).
• The storage temperature for the re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure
the battery output is not adversely af-
fected.