Werbung
Opal Design II/LED | Gelenkarmmarkise | Knikarmzonnescherm | Folding arm awning | Store à bras articulé de montage | weinor GmbH & Co. KG
Product overview
en
8
9
1
Awning box
2
Fabric
3
Front profile (without / with integrated valance plus)
4
Valance Plus fabric
Documents accompanying the product
5
Contents
en
Product overview, Contents, General
Dimensions and spacing
Prepare the mounting
Wall mounting – mounting the brackets on facades
Ceiling mounting
- Installation of brackets under roofs
Rafter mounting
- Mounting of the brackets on rafters
Hang the awning box on the brackets and fix it in place
Mounting of the Multi-section units
LED coupling for multi-panel systems
Electrical installation
Circuit diagram for Opal Design II and Option Valance Plus
Fitting the cover panels to ceiling brackets
Centering the Projection profile – adjusting the arm position
Correcting the fabric position by placing a strip of fabric underneath* 32
Adjusting and correcting the drop profile position and pitch
Product and installation inspection check list
Handover, Use, cleaning and maintenance
Disassembly, Disposal
Declaration of performance no. 221125-OD
EC Declaration of Conformity
Symbols used
6
Technische Änderungen vorbehalten | Technische wijzigingen voorbehouden | We reserve the right to make technical changes | Sous réserve de modifications techniques
10
7
6
7
8
9
10
en
Please read these instructions and observe their con-
6
tents and warnings before assemble the equipment!
10
12
Intended use
13
The weinor Opal Design II / LED folding awning arm is a sun protec-
16
tion awning that can only be used for this purpose. Misuse can lead to
hazards, damage or to collapse of the awning and is not permissible.
18
Changes, additions may only be carried out with the written permission
20
of weinor. Prohibited changes to the awning will result in voiding of the
22
guarantee claims.
26
27
Notes on the product
27
Note on the generation of noises (creaking) on the system
29
in the event of temperature changes!
30
Noises occurring on the construction which can also occur after correct
installation and/or maintenance cannot be avoided and can normally
be attributed to a length change to the profiles caused by them being
34
subjected to heat. Ensure tension-free installation when screwing the
35
individual components together in order to minimise subsequent noise
36
formation, particularly in the event of temperature influence!
37
Energy efficiency class
38
Opal Design II LED contains light sources of energy efficiency class F.
39
40
1
6
Radio remote controls (BiConnect / Somfy)
Screw sets
Wall bracket 150, 300 / Ceiling bracket 150
Crank for crank drive
Mounting plate (660x220x15/660x390x15) / (410x160x15)
General
2
3
3
4
4
5
Werbung
