Danfoss VLT Micro Drive FC 51 Serie Programmierungshandbuch Seite 65

Fehlersuche und -behebung
No. Description
52 AMT low I
nom
53 AMT motor too big
54 AMT motor too small
55 AMT Parameter out of range
63 Mechanical Brake Low
80 Drive Initialized to Default Value
84 The connection between drive andLCP is lost
85 Button disabled
86 Copy fail
87 LCP data invalid
88 LCP data not compatible
89 Parameter read only
90 Parameter database busy
91 Parameter value is not valid in this mode
92 Parameter value exceeds the min/max limits
Tabelle 6.1 Alarm/Warning Code List
(X) Dependent on parameter
A trip is the action when an alarm has appeared. The trip
will coast the motor and can be reset by pressing the reset
button or make a reset by a digital input (parameter group
5-1* [1]). The original event that caused an alarm cannot
damage the Frequenzumrichter or cause dangerous
conditions. A trip lock is an action when an alarm occurs,
which may cause damage to Frequenzumrichter or
connected parts. A Trip Lock situation can only be reset by
a power cycling.
LED indication
Warning
Alarm
The alarm words, warning words and extended status
words can be read out via serial bus or optional fieldbus
for diagnosis. See also 16-90 Alarm Word, 16-92 Warning
Word and 16-94 Ext. Status Word.
®
VLT Micro Drive FC 51 Programmierungshandbuch
Warning Alarm
yellow
flashing red
®
MG02C503 - VLT ist eine eingetragene Marke von Danfoss
Trip Lock
X
X
X
X
X
X
Error Parameter
Reference
X
X
X
X
X
X
X
X
X
65
6 6