Setting Picture; Using The Preset Picture Mode; Reducing Picture Noise; Freezing Picture - Xoro HTL 2711w Benutzerhandbuch

Using the Preset Picture Mode

1. Press MENU to display the menu main page.
The [Video] menu page will be highlighted automatically.
q
2. Press CH to select Mode
3. Press VOL+ or ENTER
p q
4. Press CH / to select a desired picture mode.
5. Press ENTER to confirm and press
There are three preset picture modes [Vivid, Standard and Mild] and one user set
picture mode [Custom].
Each preset mode has its own picture settings.
[Vivid] : Select for a bright picture.
[Standard] : Select for a normal picture.
[Mild] : Select for a fine/soft picture.
You may directly use the P.M
picture mode .
Adjustment item
Contrast
Brightness
Color
Hue *
Sharpness
The [Hue] item is for NTSC only.

Reducing Picture Noise

1. Press MENU to display the menu main page.
The [Video] menu page will be selected automatically.
q
2. Press CH repeatedly to select the
3. Press VOL+ or ENTER
p q
4. Press CH / to select.
5. Press ENTER to confirm and press
Sometimes a noisy picture may appear on the screen because of poor signal.
This function helps to enhance the picture quality by reducing the noise.

Freezing picture

Press the FREEZE button to hold on the image on the screen (the video sources
still run). Press again to reactivate the image.
Note:
l For the sake of protecting the screen,
please do NOT freeze a picture for a long time.
104

SETTING PICTURE

item.
to access the sub menu.
MENU repeatedly to exit.
button on the remote control to select a desired
Press VOL
Decrease contrast
Less bright
Lower color intensity
Towards purple
Soft picture
DNR item.
to access the sub menu.
MENU repeatedly to exit.
Value range
0 100
0 100
0 100
50 +50
0 100
Press VOL+
Increase contrast
More bright
Higher color intensity
Towards green
Sharp picture