To Stop The Engine; Pushing The Machine With The Engine Stopped - Ransomes HR6010 Sicherheits-, Bedienungs- Und Wartungshandbuch

7 OPERATION
7.7 MOWING
1. Lower the decks with the cutting unit lift
control.
2. Ensure speed limiter is in mow position
3. Engage the cutting mechanism by
pushing on the lower half of cutting unit
switch and operating the floor mounted
switch.
3. Release the parking brake and begin
driving forward.
NOTE: Always set the throttle to full for mowing,
even when the grass is heavy. When the
engine is labouring, reduce forward speed
by easing up on the FWD/RVS foot pedal.
7.8

TO STOP THE ENGINE

1. Disengage power to the cutting units with
the cutting unit switch.
2. Remove foot from the FWD/REV pedal.
3. Set the parking brake.
3. Move the throttle control lever to the
SLOW position.
4. Turn the ignition key to OFF.
7.9 PUSHING THE MACHINE WITH THE
ENGINE STOPPED
1. To push, disengage the parking brake.
2. Turn Knob (A) located under the seat
plate counter clockwise until marker on
the top is fully out. Set the steering wheel
so that the rear wheels are pointing
straight ahead.
3. Under the LH front corner of the operator
platform turn the emergency brake valve
lever (B) towards the back of the machine.
4. Turn the steering wheel to the left until
resistance can be detected. The machine
is now ready to be pushed. If unable to
move the machine apply further pressure
to the steering wheel. Excessive force
should never be used on the steering
wheel. If the rear wheels start to turn too
much force is being applied.
5. After pushing, return valve (B) and knob
(A) to their previous positions.
A
en-32
WARNING
Cutting Unit Transport Latches are a Second-
ary Safety Devise.
When Transporting the machine the Cutting
units should be held in the Transport posi-
tion on the Hydraulics with the Transport
Latches Engaged.
1. Park the machine on level ground.
2. Whilst seated in the driving position With
the engine at operating speed raise the
cutting units fully by operating lift levers,
return the lever to the neutral position.
DO NOT move the lever into the lower
position.
3. Disengage drives, stop the engine and
make sure all moving parts are stationary.
Apply brakes and remove the starter key.
4. Transport latches can now be engaged or
released.
Before releasing transport latches it is
important that all cutting units are fully
raised.