Starter Key Switch; Throttle Control Lever; Steering Wheel Rake Adjustment; Traction Foot Pedal - Ransomes HR6010 Sicherheits-, Bedienungs- Und Wartungshandbuch

6.1

STARTER KEY SWITCH

The starter key (A) should be turned clockwise to
the 'pre-heat' (No. 2) position to heat the glowplugs
when the green warning lamp goes out, on warning
lamp display module, turn the starter key clockwise
to the 'start' (No. 3) position to start the engine. After
starting, the key should be released and allowed to
return automatically to the 'on' (No. 1) position for
normal running.
6.2

THROTTLE CONTROL LEVER

The lever (B) should be moved away from the
operator to increase the engine speed and towards
the operator to decrease the engine speed.
NOTE: Engine should be used at full speed.
6.3

STEERING WHEEL RAKE ADJUSTMENT

The steering wheel is adjustable for rake. The
clamping release knob (A) is situated on the side of
the control console on the left hand side. To adjust
turn the clamping knob anticlockwise to release and
pivot the steering wheel backwards and forwards to
obtain desired setting then lock in position by
turning clamping knob clockwise.
6.4

TRACTION FOOT PEDAL

To move the machine forward press the front of the
foot pedal (A). To reverse depress the rear of the
foot pedal. When the pedal is released it will return
to its neutral position.
6.5

SPEED LIMITER

The speed limiter (B) is operated by sliding the
black knob to the right or left. When slid to the right
the machine is limited to cutting speed, when slid to
the left, transport speed is available. In transport
mode, reverse is not available.
IMPORTANT: To enable mow engage the speed
limiter must be in the cutting speed position. If
cutting units are rotating, moving the speed lim-
iter between the mow and transport positions
will engage and disengage cylinder rotation.
CONTROLS 6
A
B
A
B
A
en-23