Cutter Deck Adjustments - Ransomes HR6010 Sicherheits-, Bedienungs- Und Wartungshandbuch

8 ADJUSTMENTS

CUTTER DECK ADJUSTMENTS

8.3 CUTTER DECK BELT TENSION
Check all belts regularly during the first 5, 10 and 15
hours of operation, and then after every 50 hours of
operation. If necessary adjust as follows:
CENTER DECK
1. Adjust belt tension to 1/2" (13 mm) deflection at 10
lbs (5 kg) force at the middle of the long rear span
D. If necessary, adjust as follows:
2. Loosen locking nut on adjustment bolt E.
3. Loosen (4) bolts G fastening the motor mounting
plate to the cutter deck (3 visible in photo).
4. Turn adjustment bolt E until proper tension is
obtained.
5. Retighten (4) bolts G and lock nut on adjustment
bolt E.
WING DECKS
1. Adjust belt tension to 3/8" (10 mm) deflection at 10
lbs (5 kg) force at the middle of the long rear span
H. If necessary, adjust as follows:
2.Loosen locking nut on adjustment bolt L.
3. Loosen two bolts I fastening the idler plate to the
cutter deck.
4. Turn adjustment bolt L until proper tension is
obtained.
5. Retighten bolts I and lock nut on adjustment bolt L.
en-46