Blade Sharpening & Removal - Ransomes HR6010 Sicherheits-, Bedienungs- Und Wartungshandbuch

CUTTER DECK ADJUSTMENTS
8.4 BLADE SHARPENING & REMOVAL
When required, the cutter blades may be sharpened
either by filing or grinding. It is essential that the
balance of the blades are maintained.
NOTE: Always replace blades with original Ran-
somes blades, do not use another manufacturers
blades.
– Service the blades with the tractor turned off, and
the decks securely supported.
– Do not overheat or weaken the blades.
– If blade becomes cracked or bent, replace with a
new blade to ensure safe operation
– f lift portion of blade is worn thin replace with a new
blade to ensure safe operation
– Place block of wood W between blade and deck
baffle to prevent blade from turning during
removal
– Keep hands clear of rotating blades
Removing Blades
1. Remove the nut N from the top of the blade spindle
bolt
2. Remove the blade spindle bolt with the washer and
blade.
3. Replace the blade, washer and blade spindle bolt.
4. Tighten to 97 Nm
ADJUSTMENTS 8
en-47