End Of Season Or When Required - Ransomes HR6010 Sicherheits-, Bedienungs- Und Wartungshandbuch

9 LUBRICATION AND MAINTENANCE

9.10 END OF SEASON or when required

1. Drain Oil reservoir by removing drain plug H on
bottom of hydraulic oil reservoir.
2. Ensure that plug is clean and reinstall in tank.
3. Unscrew both filter elements G and discard.
4. Clean the rubber seal through which the filter
elements pass.
5. Apply a thin film of oil to the seals of the new filters
and install.
6. Remove plug K and add the recommended oil Fig
5) until the indicator on the oil level gauge J is
centered in the green area of the gauge. Avoid
operation in either red zone as insufficient oil
could damage hydraulic components. Too much
oil could lead to oil overflowing the reservoir as
it heats up.
7. Reinstall plug K.
8. Start the tractor and allow to run at 1/4 throttle for
approximately 5 minutes.
9. Allow oil to cool and recheck the oil level and adjust
as required.
Hydraulic oil type requirements:
Shell Tellus 46
Change Hydraulic Oil Filter(Fig.6 Ref to pg 12)
1. Wipe filter canister and housing to remove any
dirt present.
2. Place a suitable drip tray under the filter.
3. Un-screw filter canister and remove the filter
element and dispose of safely.
4. Replace with new filter element.
5. Coat the top outside lip of the filter canister with
a thin film of oil and refit the filter canister.
6. Filter should be replaced before refilling
hydraulic tank.
en-58
Fig.13
Fig.14