Mowing; To Stop The Engine; Pushing The Machine With The Engine - Ransomes HR6010 Handbuch

7 OPERATION
7.7

MOWING

1. Lower the decks with the cutting unit lift
control.
2. Ensure speed limiter is in mow position
3. Engage the cutting mechanism by pushing
on the lower half of cutting unit switch and
operating the floor mounted switch.
3. Release the parking brake and begin
driving forward.
NOTE: Always set the throttle to full for mowing,
even when the grass is heavy. When the
engine is labouring, reduce forward speed
by easing up on the FWD/RVS foot pedal.
7.8

TO STOP THE ENGINE

1. Disengage power to the cutting units with
the cutting unit switch.
2. Remove foot from the FWD/REV pedal.
3. Set the parking brake.
3. Move the throttle control lever to the SLOW
position.
4. Turn the ignition key to OFF.
7.9 PUSHING THE MACHINE WITH THE
ENGINE STOPPED
1. To push, disengage the parking brake.
2. Turn Knob (A) located under the seat plate
counter clockwise until marker on the top
is fully out. Set the steering wheel so that
the rear wheels are pointing straight ahead.
3. Under the LH front corner of the operator
platform turn the emergency brake valve
lever (B) towards the back of the machine.
4. Turn the steering wheel to the left until
resistance can be detected. The machine
is now ready to be pushed. If unable to
move the machine apply further pressure
to the steering wheel. Excessive force
should never be used on the steering
wheel. If the rear wheels start to turn too
much force is being applied.
5. After pushing, return valve (B) and knob (A)
to their previous positions.
A
en-24
SAFETY, OPERATORS & MAINTENANCE MANUAL
Cutting Unit Transport Latches are a Secondary
When Transporting the machine the Cutting
units should be held in the Transport position
on the Hydraulics with the Transport Latches
Engaged.
1. Park the machine on level ground.
2. Whilst seated in the driving position With the
engine at operating speed raise the cutting
units fully by operating lift levers, return the
lever to the neutral position.
DO NOT move the lever into the lower
3. Disengage drives, stop the engine and make
sure all moving parts are stationary. Apply
brakes and remove the starter key.
4. Transport latches can now be engaged or
released.
Before releasing transport latches it is
important that all cutting units are fully
raised.
WARNING
Safety Devise.
position.